09.08.24 findings

| No Comments

-if an API firmware is loaded, turn on "Enable API" on the "PC Settings" tab

-EVEN with an AT firmware loaded, "Enable API" on the "PC Settings" tab must be ON
-"Test/Query" only works if you turn on  "Enable API"
-in order to READ, "Enable API" must be OFF
-when the window full of text tellin you to press the reset button shows up, pull out the XBee from the FTDI board, and reconnect.  (there is no reset button!)

Leave a comment

About this Entry

This page contains a single entry by Ali Momeni published on August 24, 2009 7:07 PM.

XBee testing begins was the previous entry in this blog.

Hardware and manuals is the next entry in this blog.

Find recent content on the main index or look in the archives to find all content.